My CAPWAP® analysis shows a total capacity (Ru) greater than the applied force (FMX).Does iCAP® replace the traditional CAPWAP®?.Can I use iCAP® as a starting point for a traditional CAPWAP® analysis?. Can uplift be estimated from dynamic testing?.What Case / Smith damping factor and quake (shaft and toe) values are recommended when using CAPWAP® for specific pile soil combinations?.Is the "Match Quality" the only parameter to determine the accuracy of the results?.When is it appropriate to use "Radiation Damping", and when is it not?.In CAPWAP®, what factors should be used for radiation damping for shaft and toe?.My laptop was recently reformatted and I re-installed the PDA® and CAPWAP® software but the open PDA® file for the CAPWAP® was not able to run.What value "Match Quality" is recommended in CAPWAP®?.Thermal Evaluation of Mass Pours (TEMP).Pile Dynamics Analyzer - Dynamic Load Tester (PDA-DLT).Shaft Quantitative Inspection Device (SQUID™).Thermal Aggregator (TAG) and Thermal Acquisition Port (TAP-Edge).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |